                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1202740
Cut up Frostmourne by klowsen is licensed under the Creative Commons - Attribution - Share Alike license.
http://creativecommons.org/licenses/by-sa/3.0/

# Summary

I wanted a full scale model, but my print bed isn't nearly big enough. Hooray for Puzzlecut!

The cuts aren't NEARLY that large; I set them to -0.4 to illustrate the cut locations. In the .scad and .stl file they're set to -0.01, but that's of course configurable. 

I included HotCheeseSoup's Frostmourne.stl file. If you intend on editing the scad file, you'll need to edit the path/to/frostmourne string at the top. 

Further, the model's *REALLY* small. You'll want to scale appropriately. 10x results in a ~1.4m sword. 

Update: 3/14/2016

I've finally gotten around to uploading the .stls I used for anyone that doesn't want to go to the trouble of breaking the piece apart themselves. The pommel is...difficult. You'll want to print both parts together, on their flat side, and then join them while they're still warm from the bed. 

# Print Settings

Printer: Printrbot Play
Rafts: Yes
Supports: Yes
Resolution: 0.2mm (but 0.1mm would be better)
Infill: 20 (increase to 40+ for extra strength)

Notes: 
Try to print the parts pointing up. It helps tremendously.